Water Slide Image Transfer Decal Sheet For Polymer Clay Ceramic Glass Candles Resin - Scandinavian Floral Designs

This listing is for ONE handmade sheet of water slide decal images in the designs shown. These decals can be used on so many different surfaces: Cured Polymer Clay, Glass, Resin, Ceramic, Candles and more!
They are the perfect way to create a unique look and make your projects stand out in a crowd without breaking the bank!

The sheets measure approx. 4 x 5 inches.
The images on this particular sheet are approx. 3/4 inch max making them excellent for jewelry or small projects.

Please note that these decals have been sealed twice but will still require you to seal them once applied.
*Please also note that colors may vary from monitor to monitor.

Instructions:

Step 1: Cut out desired design leaving a small amount of space around the entire image.

Step 2: Submerge your decal in room temperature water for 20 - 30 seconds or until the paper backing can slide easily. Remove from water.

Step 3: Place decal against your project (design side facing up) in the desired position. Hold the edge of the decal while pulling/sliding the white paper backing from behind the decal.

Step 4: With a wet finger you can smooth out the decal and push out any excess water that may be underneath. Be gentle!

Step 5: Allow decal to air dry completely. At this step, the decal is not permanently adhered. If applied to ceramics or cured polymer clay you can place it in the oven at 230F or 110C for 10-15 minutes to dry it
before sealing if desired.

Step 6: Apply Sealer of your choice (Resin, Acrylic sealer etc...)